Effect of irrigation regimes and genotypes on grain yield
The pooled grain-yield data showed clear effects of irrigation regime and genotype, with a genotype × irrigation interaction also reported in the pooled analysis (Table 1). Grain yield increased progressively across the irrigation regimes at the pooled level. The lowest pooled mean grain yield was recorded under I
1 (3546.0 kg ha
-1), while I
2 and I
3 recorded 4040.6 and 4618.4 kg ha
-1, respectively. The differences among all three irrigation means exceeded the irrigation CD (336.71 kg ha
-1), indicating that each increase in irrigation level resulted in a statistically significant increase in pooled grain yield at P = 0.05.
Among genotypes, MP 3288 recorded the highest pooled grain yield (4490.7 kg ha
-1), followed by MP 3332 (4379.3 kg ha
-1). However, their difference (111.4 kg ha
-1) was smaller than the genotype CD (527.80 kg ha
-1), indicating that they did not differ significantly for pooled grain yield. MP 3288 differed significantly from HI 1572 and Lok-1, but not from HI 3000, based on the reported CD. The genotype × irrigation interaction was reported as significant, indicating that genotype performance varied across irrigation regimes; therefore, the marginal genotype means should be interpreted together with the treatment-wise values rather than as evidence of general stability or water-use efficiency. The highest treatment combination was MP 3288 under I
3 (5352 kg ha
-1).
The increase in grain yield with increasing irrigation was consistent with reports that adequate water supply during critical crop stages supports wheat yield formation.
Choudhary et al., (2021) reported improved wheat yield under optimized irrigation and nitrogen management, while
Thapa et al., (2020) described irrigation effects on yield determination under different water regimes.
Liu et al., (2022) likewise reported effects of irrigation on dry matter accumulation and yield formation. These studies provide supporting context for the present observation that higher irrigation frequency was associated with higher pooled grain yield.
The genotypic differences observed in the present study indicate variation in grain-yield performance under the tested irrigation regimes. The highest treatment-specific grain yield was recorded by MP 3288 under I
3 (5352 kg ha
-1), followed by MP 3332 under I
3 (5050 kg ha
-1) and HI 3000 under I
3 (4895 kg ha
-1). Because water-use efficiency was not calculated in the present study, the higher yields of these genotypes should be interpreted as yield performance under the imposed irrigation regimes rather than as evidence of superior water-use efficiency. The progressive improvement in grain yield with increasing irrigation indicates that water availability during critical growth and reproductive stages was an important determinant of yield formation under the conditions of the present experiment. This response agrees with findings from central India, where increasing irrigation frequency and irrigation at critical stages such as tillering, late jointing and flowering improved wheat grain yield and yield attributes in vertisols (
Sharma and Solanki, 2022). Similar results have been reported under different irrigation schedules, with adequate irrigation enhancing grain yield through improved crop growth and yield formation
(Thapa et al., 2020). Genotypic differences in the present study, together with the significant genotype × irrigation interaction, suggest that wheat genotypes differed in their response to the available moisture environment rather than showing a uniform yield response. This is consistent with studies demonstrating significant genotype × irrigation interactions for grain yield and related traits in wheat
(Mohan et al., 2008; Ram and Kaur, 2024). The particularly high yield of MP 3288 under I
3 therefore reflects its performance under the specific high-irrigation environment tested and should not be interpreted as evidence of superior water-use efficiency, since irrigation water use was not quantified. Overall, the results support the importance of matching genotype performance with irrigation availability for improving wheat productivity under the tested conditions.
Effect of irrigation regimes and genotypes on straw yield
Straw yield was significantly influenced by irrigation regime and genotype, with a genotype × irrigation interaction reported in the pooled analysis (Table 2). Pooled straw yield increased from 5330.7 kg ha
-1 under I
1 to 6105.4 kg ha
-1 under I
2 and 7038.4 kg ha
-1 under I
3. The differences between successive irrigation means exceeded the irrigation CD (614.8 kg ha
-1), indicating significant differences among the three irrigation regimes at P = 0.05.
Among genotypes, MP 3288 recorded the highest pooled straw yield (7187.7 kg ha
-1), followed by MP 3332 (6643.8 kg ha
-1). The difference between these two genotypes (543.9 kg ha
-1) was smaller than the genotype CD (917.3 kg ha
-1) and therefore was not statistically significant. MP 3288 recorded the highest straw yield under I
3 (8611.4 kg ha
-1), followed by MP 3332 (7615.4 kg ha
-1) and HI 3000 (7303.3 kg ha
-1). These treatment-wise values illustrate the genotype × irrigation response more clearly than the pooled genotype means.
The higher straw yield under increased irrigation is consistent with the role of adequate moisture in maintaining crop growth and biomass accumulation. Previous studies have similarly reported changes in wheat dry matter and straw production under contrasting irrigation regimes
(Thapa et al., 2020; Liu et al., 2022). These physiological mechanisms are presented here as explanations supported by the literature rather than as parameters measured directly in the present experiment.
The observed variation among genotypes indicates differences in biomass production under the tested irrigation regimes. However, because water-use efficiency was not measured, the present data support conclusions about straw-yield performance rather than water-use efficiency. MP 3288 had the highest pooled straw yield and the highest treatment-specific value under I
3, whereas HI 1572 and Lok-1 had lower pooled means. Such differences may reflect genetic variation in biomass production, although the underlying physiological mechanisms were not directly measured in this study. The increase in straw production with increasing irrigation indicates that greater water availability promoted vegetative biomass accumulation and maintenance of crop growth, particularly under the higher irrigation regime. Similar field studies have shown that improved irrigation increases dry-matter accumulation, tiller or stem development and ultimately straw/above-ground biomass in wheat. For example, irrigation at critical growth stages significantly increased dry-matter accumulation, effective tillers and straw yield compared with restricted irrigation, while recent work has also demonstrated increasing biomass accumulation with improved irrigation supply
(Narolia et al., 2016; Yan et al., 2022). Genotypic differences in the present study further indicate that wheat genotypes differ in their biomass-producing capacity under contrasting water availability; comparable genotype × irrigation effects on dry weight and yield have been reported in recent wheat experiments
(Singh et al., 2025; Verma et al., 2020). The particularly high straw yield of MP 3288 under I
3 therefore suggests a favourable biomass response to greater irrigation, although the underlying physiological processes were not directly measured in this experiment. Overall, the results support the role of adequate irrigation in sustaining vegetative growth and biomass production, while genotype-specific responses contribute to variation in straw yield.
Effect of irrigation regimes and genotypes on grains per spike, spikes per metre and spike length
The pooled data for grains per spike, spikes per metre and spike length showed clear effects of irrigation regime (Table 3). Grains per spike increased from 39.2 under I
1 to 41.1 under I
2 and 48.05 under I
3. However, the difference between I
1 and I
2 (1.9) was smaller than the CD (5.62), whereas the difference between I
1 and I
3 (8.85) exceeded the CD. Thus, the highest irrigation regime produced a significantly higher grains-per-spike value than I
1, while I
2 and I
3 did not differ significantly.
Spikes per metre increased from 220.5 under I
1 to 243.0 under I
2 and 261.0 under I
3. The differences between I
1 and I
2 (22.5), I
2 and I
3 (18.0) and I
1 and I
3 (40.5) exceeded the CD of 16.80, indicating significant differences among all three irrigation means. Spike length increased from 7.7 cm under I
1 to 8.1 cm under I
2 and 8.5 cm under I
3. The difference between I
1 and I
3 (0.8 cm) exceeded the CD of 0.77 cm, whereas the differences between I
1 and I
2 and between I
2 and I
3 were not significant.
Genotypic differences were trait-dependent. The genotype effect on grains per spike was non-significant (CD = NS), although MP 3288 recorded the highest numerical value (47.75), followed by MP 3332 (47.30). For spikes per metre, HI 1572 recorded the highest value (290.5) and its differences from all other genotypes exceeded the reported CD of 22.25. For spike length, MP 3288 recorded the highest numerical value (9.5 cm), but only its difference from HI 1572 (1.45 cm) exceeded the genotype CD of 1.44 cm. Thus, MP 3288 should not be described as the highest or significantly superior genotype for all three yield-contributing traits.
The increase in yield-contributing traits under higher irrigation is consistent with previous reports showing that irrigation management can influence productive tillering, spike development and grain formation in wheat
(Joy et al., 2021; Meena et al., 2019b; Li et al., 2024; Serrago et al., 2024). The present results, however, support only the measured changes in grains per spike, spikes per metre and spike length; physiological processes such as floret survival, assimilate translocation and photosynthetic activity were not directly measured.
The genotype means indicate trait-specific responses rather than a single uniformly superior genotype. MP 3288 had the highest numerical grains per spike and spike length, whereas HI 1572 had the highest spike density. Therefore, these data demonstrate variation among genotypes in yield-contributing traits under the evaluated irrigation regimes, but they do not by themselves establish differences in water-use efficiency or overall adaptability. The greater response of spike number and grain number under higher irrigation indicates that water availability during tillering and reproductive development primarily influenced sink establishment and grain-setting capacity. Similar evidence from recent wheat studies shows that irrigation can increase spike density and grains per spike, with these components contributing substantially to yield improvement under better water availability
(Ren et al., 2025). Water deficit has also been reported to restrict spike development and grain formation, with spike length and grains per spike declining as water supply becomes increasingly limited (
Bhattacharya, 2021). The present genotype differences further indicate that yield components are genetically regulated and may respond differently to irrigation; hence, a genotype with greater spike density need not necessarily have the greatest grain number or spike length. Such trait-specific responses under contrasting water regimes have also been demonstrated through genetic studies of wheat yield components
(Edae et al., 2014; Yu et al., 2020). Overall, the findings suggest that adequate irrigation favoured productive spike formation and reproductive development, while genotype-dependent variation contributed to differences in the expression of individual yield components.